What a Metal Roof Costs in Tulsa
Real ranges for the Tulsa market — by system, by roof size, materials vs. installed — so you can walk into any estimate knowing what the numbers should look like.
Get a real number for your roof
Tell us about your roof — no obligation, no pressure.
Installed cost per square foot (Tulsa area, 2026)
| System | Installed $/sq ft | Typical lifespan | Maintenance |
|---|---|---|---|
| Architectural asphalt shingles (comparison) | $4 – $7 | 18 – 25 yrs | Low, then replace |
| Exposed-fastener metal panels (29 ga) | $6 – $9 | 30 – 45 yrs | Fastener checkups |
| Exposed-fastener metal panels (26 ga) | $7 – $10 | 40 – 50 yrs | Fastener checkups |
| Standing seam (24 ga, PVDF finish) | $10 – $16 | 50 – 70 yrs | Minimal |
Ranges reflect typical Tulsa-market quotes for complete installations (underlayment, trim, flashing, labor) on walkable-to-moderate pitches. Steep, cut-up, or multi-story roofs price higher. Roof area is measured on the roof, not the floor plan — a 2,000 sq ft single-story home commonly carries a 2,200–2,600 sq ft roof.
Installed cost by roof size
| Roof area | Exposed-fastener panels | Standing seam |
|---|---|---|
| 1,500 sq ft | $9,000 – $15,000 | $15,000 – $24,000 |
| 2,000 sq ft | $12,000 – $20,000 | $20,000 – $32,000 |
| 2,500 sq ft | $15,000 – $25,000 | $25,000 – $40,000 |
| 3,000 sq ft | $18,000 – $30,000 | $30,000 – $48,000 |
Materials only (for the DIY crowd)
Buying panels for a barn, shop, or self-install? Common 29-gauge ribbed panels run roughly $2 – $3.50 per sq ft in materials; standing seam panel stock with clips and trim runs roughly $4 – $7 per sq ft. Local Tulsa panel suppliers roll-form to length — that's a supplier purchase, not an installer job, and this site won't try to talk you out of it. When you want the roof installed and warranted on your home, that's where the free estimate comes in.
What moves the number most
In rough order of impact: system choice (seam vs. screw-down is the biggest swing), roof complexity and pitch, tear-off (removing old layers adds $1–$2/sq ft), gauge and finish (24 ga PVDF outlasts and outprices 29 ga SMP), and trim/flashing detail (chimneys, skylights, dead valleys). A good written quote itemizes all five — if a bid is one number on a page, ask for the breakdown.
Want a firm number instead of a range?
A licensed Tulsa metal roofing contractor will measure your actual roof and quote your actual options — free, written, no obligation.